Challenge #127 JUST BEACHY &/or RED WHITE & BLUE

Ha! Finally got chance to create something for Let's Craft and Create.

I waited for long time to participate. These are my favourite colour and I can create end number of cards using these three colours. So here is my post for the entry.

Product used :

1. Card Stock -Blue, Red and White

2. Paper Doily

3. Mudra Stamp -Lets Party

4. Pattern paper

5. Gina Marie Designs - Circle stitched die

6. Distress Ink - Vintage photo

7. Tacky Glue

8. Tacky Tape

9. Martha Stewart Score Board.

10. Scissors

Procedure : -

To create the banner I scored A4 red card stock using Martha stewart score board at 2 and 4 cut it in 2 parts and joined two strip to one long strip. Scored again vertical  at 1//2 inch interval till end. Joining two ends with tacky glue I very softly pressed the centre to make a flower circle. Hold it for 2min as the card stock little is thick. I then put doily on top. Die cut the circle using Gina Marie Dies in 4 shapes. One blue, White, Red and again red. Stamped with Mudra stamp on the top of the red card stock. From small rectangle red card chopped from middle to create the two ribbons at the end.

Ready to go.. Thank you for your valuable time.

Bye

Alka

Paper Sweeties - CELEBRATE THE RED, WHITE & BLUE!!!

Super Super exited to share Paper Sweeties - CELEBRATE THE RED, WHITE & BLUE!!! in my blog.

The colours of this challenge is so vibrant. I just loved them. Fortunately I had all the elements that is required for this challenge.

Products used :-
1. DCWV Adhersive mat stack prints- (sticker paper)
2. White card stock
3.Craft Medley -Cup Sequins (multi Colour) from Multi craft
4. Tacky tape
5. OHP Sheet
6. Tacky Glue
7. Tag Sentiments from Eco Greetings
8. Unbranded Rectangle die
9. Double sided tape

Instructions:-

I have used rectangle die to cut the window. The background is the Blank card wanted to stamp the sentiments but I had the tag that was exactly matching with the entire card.

Keep the OHP sheet 1/2 inch bigger than the cut so that I can glued properly. I have used tacky tape to avoid the mess that glue creates.

Used foam double sided in 2 layers this will accommodate the sequins beautifully and shakes very well. It gives enough space to move the sequins. I have sticked sequins little here and there so that when the card is upright it can be clearly visible.

I enjoyed making card and in this busy week day Monday! I could post that same.

Do like, share and spread my blog link.

Thank you so much!